FS-6025 Code 0180

[Pinoy_Tech]

Hi all, is there anybody experienced trouble with Kyocera FS-6025 about code 0180? It pertains to a mismatch serial number of engine and main PWB (EEPROM).

The trouble occurred during installation and never even make a single copy on it. I ran the program 004 under mode 3036 but no luck with this program. When I'm performing this program, the serial number is appearing on the lower part of the LCD and the machine is asking if I want to re-write the data, it appears that the serial is not registered yet on the EEPROM. While we have lot of new sold machines in field, I compared this program to other well known running machine but the scenario is not the same. On running machine, the serial number is positioned on the upper part of LCD and the machine has no suggestion of rewriting the data. Then I go to the next step by swapping all possible suspected items to the known running machine (engine and main pwb swapped at the same time with eeprom) but never succeeded too. The only remaining I didn't swapped are the covers, frames, and wirings. If I'm going to put the engine & main pcb with eeprom to the other machine, the trouble code 0180 is appearing there, while the good working pcb's from the other machine is not working on the main target machine. Omg, what is this trouble about!


Any advice guys... TIA

[mannaro75]

Re: FS-6025 Code 0180

LOOK AT THIS SB

[taskalfaman]

Re: FS-6025 Code 0180

hi,

please go into maint mode.
select 004.
go down untill action.
confirm.
code should be gone.

best regards.

[Pinoy_Tech]

Re: FS-6025 Code 0180

LOOK AT THIS SB

hi,

please go into maint mode.
select 004.
go down untill action.
confirm.
code should be gone.

best regards.

Thanks both of you for your concern. So sad that the machine is not in my hands at this time because I forwarded it to our head office and from there they contacted the manufacturer 'till they sent the eeprom to Taskalfa support center but still there's no improvement as I heard. I'm sure they already done the same procedures as you suggested, same as my preliminary steps I've done during my first attempt to fix the trouble but it is not solving by that way. However, a new unit has been given already to the same client that makes my headache clear instantly!

I just want to correct, I mention on my first post that I ran program 3036. It's my mistake because this model is not supporting this programming mode, program mode can be access the same 1087.

Off topic; one more to add, I have a big puzzle on my mind that right after I plugged my new USB to the USB port of this model for printing some files, my usb is not accessible anymore to any other computer (it's not going to open) but with this model it is possible to open, omg!

[acusso1234]

Re: FS-6025 Code 0180

I believe that a low level format can fix your pen drive. It worked for me in the past. You can find a freeware program on the net.