FS-1028/1128 clutch problems

[campy]

Has anyone had problems with the clutch pack on these? I have only around a dozen in the field and we have had to replace clutches on at least 3 of them. The symptoms are the registration is off by a little as a half inch to several inches, due to the registration clutch slipping from being dirty and will jam because the timing is so far off. What appears to be happening is the drum with the image is further along than the paper so the bottom 2/3 rds of the image is lead edge of the copy paper, in other words if you put an arrow on top and bottom of original the trail edge arrow image is 3-4 inches up from the trail edge of paper. The clutch pack cost around a $100 so it's now starting to piss me off and will probably stop selling them and go back to Canon.

[Venom]

Re: FS-1028/1128 clutch problems

Ya, the clutches are bad on these, have seen 3 bad registration clutches and 1 developer clutch bad

[Zackuth]

Re: FS-1028/1128 clutch problems

We have over 70 of these out in the field and have had to replace only 1 clutch pack. Most of our problems are with fusers. Thanks for the heads up, we'll keep an eye on it.

[Venom]

Re: FS-1028/1128 clutch problems

We have over 70 of these out in the field and have had to replace only 1 clutch pack. Most of our problems are with fusers. Thanks for the heads up, we'll keep an eye on it.

Yes fusers have been a problem as well, the frame warps and thermostat grinds into hot roller, we have been making sure that the sleep timers are set for 60 minutes now.

[Zackuth]

Re: FS-1028/1128 clutch problems

Venom, not a bad idea!! I'm going to run that by the boss.

[mikeb721]

Re: FS-1028/1128 clutch problems

new software has been released to fix the fuser issue, I havent tried it yet but i'm hopefull

[ACMTech]

Re: FS-1028/1128 clutch problems

Ya, the clutches are bad on these, have seen 3 bad registration clutches and 1 developer clutch bad

Hello,

What is the part number for the registration clutch pack?

[Masterchief]

Re: FS-1028/1128 clutch problems

We have a customer who has many of these with platen covers, mainly used for printing. I have had customers lean on these and damage the frame which results in off set reg

[mikeb721]

Re: FS-1028/1128 clutch problems

actually the problem turned out to be a gummed up reg. roller whatever lube they put on at the factory went hard. I just removed and cleaned the upper reg. roller and problem solved. so try that before replacing any parts.