If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The hard disk on my Kyocera CS2525E is burnt. Is a seagate 40gb ide 7200 rpm. How can i change it? What is the procedure for the machine to recognise a new hard drive? Do i have to get the exact same model of hard in order to change it?
The hard disk on my Kyocera CS2525E is burnt. Is a seagate 40gb ide 7200 rpm. How can i change it? What is the procedure for the machine to recognise a new hard drive? Do i have to get the exact same model of hard in order to change it?
just had the same problem .any hard disk (not sata )any make will do i usually put in a 80gb as 40 are hard to get.just plug it in and do a format via service mode and all should be ok.
Comment