[Misc] document feeder - km 2550

[daveh12]

Hello everyone

Having trouble with a document feeder not doing anything when you press the green button to copy. Machine is picking up that there is a df attached and it is sensing the correct size paper by the display on the machine but when you go copy nothing happens in the df and the machine prints out blank page. No jam codes.

Replaced various parts and even tried a whole new df. Same thing happens. Will have to try a different engine board but as I don't have one yet just wondering could it be anything else?
Thanks

[JustManuals]

Re: document feeder - km 2550

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[monstott2010]

Re: document feeder - km 2550

Hello everyone

Having trouble with a document feeder not doing anything when you press the green button to copy. Machine is picking up that there is a df attached and it is sensing the correct size paper by the display on the machine but when you go copy nothing happens in the df and the machine prints out blank page. No jam codes.

Replaced various parts and even tried a whole new df. Same thing happens. Will have to try a different engine board but as I don't have one yet just wondering could it be anything else?
Thanks

We have had that happen before, I believe it was the engine board that caused the problem

[Geo]

Re: document feeder - km 2550

We have had that happen before, I believe it was the engine board that caused the problem

We fixed a similar problem by replacing the doc feeder interface cable.

[jmoc]

Re: document feeder - km 2550

try a sim 906 on it ??








QUOTE=daveh12;364822]Hello everyone

Having trouble with a document feeder not doing anything when you press the green button to copy. Machine is picking up that there is a df attached and it is sensing the correct size paper by the display on the machine but when you go copy nothing happens in the df and the machine prints out blank page. No jam codes.

Replaced various parts and even tried a whole new df. Same thing happens. Will have to try a different engine board but as I don't have one yet just wondering could it be anything else?
Thanks[/QUOTE]