[Misc] add toner on Fs 3140mfp when cartridge is full

[kyogenius]

Has anyone had this problem before on Fs 3140mfp ,it continuously say adding toner ,there is a noise on the cartridge as if it's not sitting properly,but the cartridge has been shaken properly and properly clipped.what could be the cause for this?

If I activate the front cover door switch and slightly press the cartridge down for a little while the noise goes and the add toner disappears.Any new modification on new dev units or the cartridges themselves.Any help welcome.

[JustManuals]

Re: add toner on Fs 3140mfp when cartridge is full


This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads




Paul@justmanuals.com

[madas]

Re: add toner on Fs 3140mfp when cartridge is full

I would check the cartridge gear alignment, on some earlier models the gear to open the toner slot were out of postion, although this made it hard to remove the cartridge from the m/c

also trick the door switch and see if the toner loading motor turns! right side in the dev unit.

check in the dev unit to see if any toner is getting in the opening, if it is crammed with toner it could be a faulty dev unit. if it is empty then either the cartridge is not opening or the motor is not turning.

a couple of ideas for ya.

Madas

[kyogenius]

Re: add toner on Fs 3140mfp when cartridge is full

Thanks man,more likely it could be the earlier type of dev units that for some reason do not tightly clip the toner cartridge to the gears that are driven by the toner feed motor.
I discovered all this after cheating on the switches for the door covers.Anyway I managed to sort the problem out