I can make good copies with my CS-1815 if I am doing one or two copies, but when I make 8 to 12 copies there is atleast one or two within the copies that is not right, the leading edge is off (the image has shifted up). I have changed the imaging unit and still I have the same problem. anyone what else I should try?
-
-
Re: Copystar CS-1815 Leading edge is off
Registration clutch and/or solenoid. -
Re: Copystar CS-1815 Leading edge is off
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Paul@justmanuals.comComment
-
Re: Copystar CS-1815 Leading edge is off
the foam pad on the lever of the registration solenoid has gotten old and causing the lever to stick. You can clean up the gunk and replace the pad or do like I do with a bit of paper and tape. Clean it up then put it together and leave the side over off, run it, and make sure the solenoid is not sticking."In a cruel and evil world, being cynical can allow you to get some entertainment out of it."
Comment
Comment