KM 2050 soiled/background on back of copy/print leading edge

[brotherlarry]

I have a KM 2050 that makes a copy/print with about 2 inches of background on the leading edge of the rear of the copy/print. I am changing the transfer assy. today

[MR Bill]

Re: KM 2050 soiled/background on back of copy/print leading edge

While you are there dump that crappy generic toner and set it up with OEM toner. That will fix the problem.

[brotherlarry]

Crappy Plain White boxToner

Lol

[MR Bill]

Re: KM 2050 soiled/background on back of copy/print leading edge

Hello brother Larry. I have had this problem before and generic toner does mess up your CQ. Background on the back of the page is 1 problem with non oem toner.

[brotherlarry]

Its been using the same toner for 2 years Densi with no problems. I had this with a 1620 was the transfer rollers conductive holders

[MR Bill]

Re: KM 2050 soiled/background on back of copy/print leading edge

Well OK then. Hope your T.R. fixes the problem for you. BUT, I would guess that quility control from some of the venders might vary? So just keep that in the back of your mind if your problem is not fixed with T.R. holder.

[kkendric]

Re: KM 2050 soiled/background on back of copy/print leading edge

It is truly amazing that some copier people do absolutely no research on their problems before they ask for help. how many times have toner problems been addressed on this forum? Especially this series. If you want long life for your Kyocera product always use Kyocera products as they were designed for them. You may save money up front using aftermarket toner, but it will cost you more in the long run.