If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Have you run the ColorRegistration? Adujst them manually. I guess that might help.
You may have to do it several times.
Good luck on this.
Regarts
I made the manual color registration in vain. When I pull out drums and transfer belt and I go them back, the first print is corect but after the problem returns. I will be glad if there is a service bulletin about this problem.
Hi,
we also had the problem, in our case recurrent sporadically color shift in direction feed.
On Simulation U089, 20 Expression created, 19 OK, 1 faulty.
Solution: installl new TR-8505 TRANSFER UNIT
Hi,
we also had the problem, in our case recurrent sporadically color shift in direction feed.
On Simulation U089, 20 Expression created, 19 OK, 1 faulty.
Solution: installl new TR-8505 TRANSFER UNIT
Regards
My problem was in the transfer belt as you said. But I didn't change it. I cleaned the sensor (see Attachment) of the belt rotation speed and it's ok. Thank you all.
Comment