Hello,
one my customer has problem (very slow printing) from Autodesk Invertor 2015 (W7pro-64bit) to Kyocera TA300i (2GB memory).
He uses Classic Universal Driver KPDL ver. 2.93 (this driver were recomanded by Autodesk)
Aditionally customer says that this bad behavior (phenomenom) is noticeable only during last month and he also says that no changes were made on the settings of system and driver.
Hard to say if it is true.
Of course I tried to uninstall driver, clean off unused printer drivers from system and install it again, but no help.
Is there anybody here with some experience or recomandition ?
Thanks.
one my customer has problem (very slow printing) from Autodesk Invertor 2015 (W7pro-64bit) to Kyocera TA300i (2GB memory).
He uses Classic Universal Driver KPDL ver. 2.93 (this driver were recomanded by Autodesk)
Aditionally customer says that this bad behavior (phenomenom) is noticeable only during last month and he also says that no changes were made on the settings of system and driver.
Hard to say if it is true.
Of course I tried to uninstall driver, clean off unused printer drivers from system and install it again, but no help.
Is there anybody here with some experience or recomandition ?
Thanks.