Muratec MFX-2050 String Feeding

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • CopyTech03
    Technician

    50+ Posts
    • Jul 2020
    • 52
    #1

    [Jamming] Muratec MFX-2050 String Feeding

    Muratec MFX-2050 will pull 2 sheets one behind the other, like the clutch isn't turning off. Doesn't do it all the time. Replaced the feed roller, sep pad, clutch, and sensor. Anyone else run across this issue or have any idea what it could be?
    Tags: clutch, mfx-2050, muratec, run, sensor
    • mojorolla
      The Wolf

      2,500+ Posts
      • Jan 2010
      • 2550
      #2
      Re: Muratec MFX-2050 String Feeding

      What is the jam code?


      Failing to plan is planning to fail!!!

        Comment

        • CopyTech03
          Technician

          50+ Posts
          • Jul 2020
          • 52
          #3
          Re: Muratec MFX-2050 String Feeding

          Originally posted by mojorolla
          What is the jam code?


          It just says check paper size. The copy/print is halfway out the machine (trail edge just out the fuser) and the blank sheet is right behind it which is causing the jam indication.

            Comment

            • CopyTech03
              Technician

              50+ Posts
              • Jul 2020
              • 52
              #4
              Re: Muratec MFX-2050 String Feeding

              Originally posted by CopyTech03
              It just says check paper size. The copy/print is halfway out the machine (trail edge just out the fuser) and the blank sheet is right behind it which is causing the jam indication.
              PROBLEM SOLVED - Just in case anyone else runs into this problem it was the feed solenoid on the back of the machine. The plate was staying engaged with the solenoid magnet (residual magnetism). I put electrical tape on the back of the plate and problem solved.

                Comment

                Previous template Next
                Working...