Good morning everyone!
Got a problem with this model,it worked for many years without any problems but recently it started spamming problems non stop.
In particular when the machine boots if it finds a faulty printhead it starts the wizard to change it right?BUT when you press next at the first step
(which indicates the faulty ph) it freezes and does nothing.
You have to reboot her 4-5 and even then it may let you run the wizard..
I have a lack in experience with these machines but could this be a firmware problem?
Any feedback is welcome!
Thanks in advance!
Got a problem with this model,it worked for many years without any problems but recently it started spamming problems non stop.
In particular when the machine boots if it finds a faulty printhead it starts the wizard to change it right?BUT when you press next at the first step
(which indicates the faulty ph) it freezes and does nothing.
You have to reboot her 4-5 and even then it may let you run the wizard..
I have a lack in experience with these machines but could this be a firmware problem?
Any feedback is welcome!
Thanks in advance!