Just replaced a full set of drums on the unit. Looked ok when i left but a few days later the customer called with a print quality issue. I went and checked it out and it appears as though the Yellow registration is off a hair or two. I tried to adjust it via the menu ..aka Yellow fine registration adjustment, but +3 or -3 seem to make no difference whatsoever on the Demo1 page the printer provides.
Is there an extended service mode where i can print better test pages on this thing?
or any other input would be appreciated.
Is there an extended service mode where i can print better test pages on this thing?
or any other input would be appreciated.
Comment