Magic color 2500w bad printing quality

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Zilviux
    Technician
    • Apr 2009
    • 32

    #1

    [Misc] Magic color 2500w bad printing quality

    Hello I got this printer and the problem is that prints came out with not enought toner and it looks like draft quality (like on ink based printers) I have change fusing unit but still the same, also check image unit and transfer belt by force stoping open cover while printing, on image unit all clear and sharp on transfer belt also good, but on paper goes bad quality, its seems the problem is then print goes from belt to paper or its not engouth pressed or its cleaning by mechanics..
    May be someone have this issue? before was everything is ok but one day my colegue try some spelial print media for t-shirts and its jam in printer, after he take out from printer started this problem...
  • fixthecopier
    ALIEN OVERLORD

    2,500+ Posts
    • Apr 2008
    • 4714

    #2
    The transfer roller is what pulls the image off the belt, did you change it?
    The greatest enemy of knowledge isn't ignorance, it is the illusion of knowledge. Stephen Hawking

    Comment

    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838

      #3
      This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


      Paul@justmanuals.com

      Comment

      • Zilviux
        Technician
        • Apr 2009
        • 32

        #4
        I m not sure which is but i tryed the change black one which fitted o printer, so improve in top and bottom of page just 20% rest left the same

        Comment

        • Zilviux
          Technician
          • Apr 2009
          • 32

          #5
          ok so this is the part, i have tryed to remove from my working 2450 and put again, and now this 2450 prints like 2500 in bad quality...
          so is were some instructions to adjust or fix it?

          Comment

          • Zilviux
            Technician
            • Apr 2009
            • 32

            #6
            SOLVED

            Found the problem when i was chaching i was forget to put spiral contact to roller, now everithing work ok on both

            Comment

            Working...