I have been fighting with some of these 3640's for several months.
On all three that I have been working on the overall density seems to be far too light on prints and copies. Due to several events I have actually cannibalized the three machines to make one solid box at this time. In doing so, I have ruled out just about all hardware issues.
There is a automatic calibration option (a print, scan, calibrate type), but it does not seem to want to capitulate; therefore, I cannot calibrate these machines.
Anyone know of a procedure for calibrating these things?
Thanks!
On all three that I have been working on the overall density seems to be far too light on prints and copies. Due to several events I have actually cannibalized the three machines to make one solid box at this time. In doing so, I have ruled out just about all hardware issues.
There is a automatic calibration option (a print, scan, calibrate type), but it does not seem to want to capitulate; therefore, I cannot calibrate these machines.
Anyone know of a procedure for calibrating these things?
Thanks!