Iradvc 2030 laser unit

[madas]

Hi guys
I hope someone can help on this, I accidentally broke the ribbon cable connector on the laser unit, pulled it off the board no less.

I have access to one from another m/c but am unsure of any changes to settings. Not much luck in the service manual, have any of you swapped the units from m/c's without any original paper work for the values of settings to be changed?

Heres hoping.

madas


PS
just had a thought that if the m/c I'm going to take it out of is running I should be able to get the settings there? But it might not be a complete m/c.

[canonbundy]

Re: Iradvc 2030 laser unit

Hi guys
I hope someone can help on this, I accidentally broke the ribbon cable connector on the laser unit, pulled it off the board no less.

I have access to one from another m/c but am unsure of any changes to settings. Not much luck in the service manual, have any of you swapped the units from m/c's without any original paper work for the values of settings to be changed?

Heres hoping.

madas


PS
just had a thought that if the m/c I'm going to take it out of is running I should be able to get the settings there? But it might not be a complete m/c.

Unit is the same as an ADV2230 - usually the exchange doesn't require any major setup/changes.

[laitang]

Re: Iradvc 2030 laser unit

Attach document should be helful

[madas]

Re: Iradvc 2030 laser unit

thanks guys,
I wished I had that PDF before as that last bit is exactly what happened I missed the rail and the flat cable caught inside.

wont do that again! I hope

madas