If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi all, any help on pansonic 3030 dev setup after replacing dev.thanks
yes, you vacume out the process unit ,make sure the mag roller is clean.
go to service mode do a F8-09 wait till it`s done. then open the right side door check to see the that the toner density sensors are clean off.
then do a F8-14 wait till it`s done and thats it.
Comment