If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Anyone have any problems with them going out? We've had a few stop working. Re seat connectors on SC board and problem is fixed for a while but comes back. Just wondering if anyone has seen this issue yet. Thanks!
Ive been working on these for a few years and have never had a lamp go bad.
Heh heh, Sounds like the kiss of death to me.
I don't think I've ever seen a lamp go out before, but I think I've seen a tech replace to correct copy quality. I have had the scanned pages going blank before, apparently, replacing the SC board fixed it.
Comment