If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Has any one seen this?? Machine shuts off and on!!
Power supply maybe???
I've seen a bad surge protector do this.
Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
Ya know what? I remember, I've had a few of these machines where if you went from 1 sided originals to two sided originals and then back to 1 sided originals, the machine would reboot. I've never really trouble shot the problem, beyond swapping out the feeder, but then it always seemed to happen when we had a surplus of ADFs. My guess is there is a shorted harness likely related to the gate solenoid. Hope this helps, Good Luck!
Comment