[Misc] Panasonic DPC 354 User Codes

[xxmandingoxx]

been working on these things for years but just recently got promoted "because the other guy got canned" so i never actually did any of the initial setup as far as user codes

i have a customer with user codes already enabled and he wants to add another one, can anyone post up a walkthrough?

thanks!

[JustManuals]

This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from http://www.justmanuals.com

Paul@justmanuals.com

[mojorolla]

The function is turned on and off in F5 service mode. From your post it is already on so go into the user menus. FUNCTION, GENERAL SETTINGS, KEY OP MODE, then #14 DEPT COUNTER MODE. You can add/delete from here.

[xxmandingoxx]

thanks a bunch that worked, but now when they try to print it wont go throught what settings do i need to change to makeit so they can print?

[KalEl]

You probably have to input the user id into the print driver for it to authorise.

[xxmandingoxx]

well yes, but thats what im trying to figure out, where that might be

[KalEl]

Just had a quick look at the 263 driver we have and it seems to be in printing preferences and job type tab and then dept id at the bottom.... Not positive though. Goob luck.

[xxmandingoxx]

Just had a quick look at the 263 driver we have and it seems to be in printing preferences and job type tab and then dept id at the bottom.... Not positive though. Goob luck.

well done sir, tested & working