DP 8035 how to install?

[jummamaster]

How to initialize a new DP 8035 machine. I no nothing about Panasonic copiers but have a new machine to install. Please help.

[tmaze01]

Re: DP 8035 how to install?

How to initialize a new DP 8035 machine. I no nothing about Panasonic copiers but have a new machine to install. Please help.

Panasonic copiers are user and tech friendly they should come with a print option already installed (if they are going to use it as a printer with multiple computers the only thing you will need to do as far as installation is configure the network) if used as a copier only, then just plug it in, do a basic key op "how to make copies,remove jams, replace toner..etc... and your good also with panasonic you will find it has the option to reset all of consumables from the touch screen (drums, fusers, belts etc.. without replacing any kind of pico fuse or small gma fuses) that other copiers require to reset. as far as reseting consumables drums only once fusers as long as rollers look good and not jamming.

hope this helps

taylor

[JustManuals]

Re: DP 8035 how to install?

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[jummamaster]

Re: DP 8035 how to install?

thanks tmezo.

[mojorolla]

Re: DP 8035 how to install?

In F9 service mode, there is a setting called "shipment set". This will initialize/wipe out all the settings in the machine as if it were just out of the box.

[xxmandingoxx]

Re: DP 8035 how to install?

if you dont have the CD's install the print drivers from panasonic.net they are free and accessible by anyone. Good luck,

[PanaTech]

Re: DP 8035 how to install?

there is a screw beside the pressure roller knob(big green knob after u open the door), use a flat head screw drive to turn clockwise to unlock the pressure( u can tell the difference by turning the big green knob on the left). then unscrew the clear cover on the right that covers a harness and turn the black lever by 90 degrees clockwise and pull the developer unit out, and put in new developer(it should come with the unit, if it is new). then put everything back in, put toner in and then turn on the machine, and go to service mode Function+ledger (original size)+3, it will ask u for password, default password is "00000000" (eight zeros). and 8, start, 9, start (this will do toner desity adj, it takes about 8mins), when itz done. are r good to go.

[premiertraders]

Re: DP 8035 how to install?

there is a screw beside the pressure roller knob(big green knob after u open the door), use a flat head screw drive to turn clockwise to unlock the pressure( u can tell the difference by turning the big green knob on the left). then unscrew the clear cover on the right that covers a harness and turn the black lever by 90 degrees clockwise and pull the developer unit out, and put in new developer(it should come with the unit, if it is new). then put everything back in, put toner in and then turn on the machine, and go to service mode Function+ledger (original size)+3, it will ask u for password, default password is "00000000" (eight zeros). and 8, start, 9, start (this will do toner desity adj, it takes about 8mins), when itz done. are r good to go.

i need firmware dp 8035, bcoz we have 220volt machine , but i import 110volt . but there is size problem in letter by A4.