I have this machine that is using up coronas in 40 to 50 thousand copies. Replaced sep unit and main charge because I thought I saw cracks in them. Back there today for same prob after 43000 copies. Any suggestions? Thanks.
Coronas dp 8035
Collapse
X
-
Re: Coronas dp 8035
I have had that same issue with the black wavy lines. Replacing corona grid / wires doesn't fix it.
I had to change the F6-17. I don't remember which way I bumped it, up or down but I had to change the default setting by 30 points and it fixed the issue. 8060, 8045, and 8035 all (1 of each had this issue) with over 450k on the meter.Comment
-
Re: Coronas dp 8035
I refer to the black wavy lines as "smoke lines". This happens all the time on this model. I start with the charge wire, then the grid. Over time, the rear metal post the wire attaches to will melt and deform the plastic surrounding it, causing image issues. Also check the 2 screws that anchor the transfer/sep corona under the drum. This is the arm lifted to remove a duplex jam, make sure it has no wiggle.
Failing to plan is planning to fail!!!Comment
Comment