Panasonic 8020 U25

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • prabh81
    Technician
    • Jan 2009
    • 12

    #1

    [Error Code] Panasonic 8020 U25

    Dear Experts,

    i am having problem with this U25 code in Panasonic 8020 machine after resting it will occur after 20-25 copiers, even i have changed developer.


    With Regards
    Prabhdeep
  • doug94550
    Trusted Tech

    100+ Posts
    • Dec 2011
    • 138

    #2
    Re: Panasonic 8020 U25

    The problem is that toner is not being dispensed to the developer. Every time I have seen this it has been the toner in the tube is compacted which prevents the toner auger from rotating. It happens on the 3030 series also. Go ahead and really shake up the toner tube to loosen the toner so it will flow freely. Then physically rotate the toner auger from the rear of the tube. I use a large standard screwdriver rather than trying to grab it with my fingers. If the auger will not rotate you will need to install new toner. Also, check to see if the toner motor is actually turning on. If not, you have bigger problems.

    Comment

    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838

      #3
      Re: Panasonic 8020 U25

      This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


      Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


      Paul@justmanuals.com

      Comment

      • copiman
        Technician

        500+ Posts
        • Sep 2011
        • 861

        #4
        Re: Panasonic 8020 U25

        Another thing to check is the auger from where the toner drops from the tube and is auged into the dev unit. Make sure it is functioning ok. Also, the drive for the auger gets stuck and does not contact the drive from the machine (spring loaded).

        Comment

        • prabh81
          Technician
          • Jan 2009
          • 12

          #5
          Re: Panasonic 8020 U25

          Originally posted by doug94550
          The problem is that toner is not being dispensed to the developer. Every time I have seen this it has been the toner in the tube is compacted which prevents the toner auger from rotating. It happens on the 3030 series also. Go ahead and really shake up the toner tube to loosen the toner so it will flow freely. Then physically rotate the toner auger from the rear of the tube. I use a large standard screwdriver rather than trying to grab it with my fingers. If the auger will not rotate you will need to install new toner. Also, check to see if the toner motor is actually turning on. If not, you have bigger problems.
          i had try this but it never works!!!

          Comment

          Working...