I am trying to adjust the printer registration as indicated on page 223 of the svc manual. I have completed the side to side adjustment just fine. Here is where i am:
11X17 in tray 2.
Printed test pattern 1
Adjusted F6-05 Reg B/W normal
No change occurs. One thing to add is I did not do F8-28 (belt length control). This is a used machine. Not sure if doing it would knock something out of wack.
Why do they have to make it so complicated. So many adjustment for registration-slow, fast, half speed, full speed, color, b/w, etc.........
Any guidence on this would be greatly appreciated.
11X17 in tray 2.
Printed test pattern 1
Adjusted F6-05 Reg B/W normal
No change occurs. One thing to add is I did not do F8-28 (belt length control). This is a used machine. Not sure if doing it would knock something out of wack.
Why do they have to make it so complicated. So many adjustment for registration-slow, fast, half speed, full speed, color, b/w, etc.........
Any guidence on this would be greatly appreciated.
Comment