If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Rebuild them. Order the heat roll, press roll, and the two black plastic "bearings". The plastic bearings are what usually break.
Panasonic always has them and total cost is around 90 bucks.
Panasonic has these back ordered until 4-17-2015, Kyocera uses the same fuser unit in one of their machines, but the cost is almost double the cost from Panasonic. Toshiba also has a unit, but again, the cost of them makes it hard to justify.
Does anyone know of a source for these fusers that is priced reasonably?
Leave a comment: