MPC 4500 with SC230 (new machine)
anybody ran across this error code and know what it is. This is a new machine out of the box with about only 250 to 300 copies on it. At installation everything was fine so a board isn't likely.
-
-
I have not had this code but manual said its an f gate signal problem -
Reload ALL firmware. Check to see if ACC passes on all copy and print modes, run forced process control in all modes to see if any fail.
If that fails replace IPU, replace BICU, smash bastard machine with sledgehammer.
They're a favourite at the minute for unspeakable firmware issues.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
Comment