MPC2503 Ghosting

[EOJTech]

Have a ghost image on print only that is 94mm from the original image. Roller pitch guide suggests fusing sleeve or drum. To date, fusing sleeve, pressure roller, K drum, ITB assembly all replaced, and firmware is up-to-date. Sounds like a fishing expedition, but that's what tech support suggested. Any ideas?

[Oze]

Re: MPC2503 Ghosting

Have a ghost image on print only that is 94mm from the original image. Roller pitch guide suggests fusing sleeve or drum. To date, fusing sleeve, pressure roller, K drum, ITB assembly all replaced, and firmware is up-to-date. Sounds like a fishing expedition, but that's what tech support suggested. Any ideas?

There's a bulletin for this range that says to up the toner ratios.

[Mark Bbb]

Re: MPC2503 Ghosting

TCB...