[Misc] MPC3003 Original is not detected on glass

[hanspeter75]

As in the title. When copying always 2 x Start must be pressed in Auto Mod..Scannen from Glass also does not go. About ADF no problem.
Controls: Sensors ADF and glass, Controller, Lens Block, SIO. Resetting the display setting ... not a success, an idea?
Greeting

[LNorris]

Re: MPC3003 Original is not detected on glass

when u press copy the first time, what does the screen tell you?

[slimslob]

Re: MPC3003 Original is not detected on glass

What size is the original?

[hanspeter75]

Re: MPC3003 Original is not detected on glass

Hi
The Screen say "Orginal not detected" and it makes it with any format(A6-A3).

[slimslob]

Re: MPC3003 Original is not detected on glass

Sounds lie your paper length sensors under the platen glass are dirty, defective or have loose connections.

[hanspeter75]

Re: MPC3003 Original is not detected on glass

Hi
both replaced ... no success

[ennadhe]

Re: MPC3003 Original is not detected on glass

Do you hear any beep sound upon inserting the original?, maybe you have a problem with original detection sensor.

[hanspeter75]

Re: MPC3003 Original is not detected on glass

ADF liftsensor? do you mean the ADF open or close Sensor...looks good, the flag goes inside.

[slimslob]

Re: MPC3003 Original is not detected on glass

ADF liftsensor? do you mean the ADF open or close Sensor...looks good, the flag goes inside.

When you close the ADF does the scanner move out and turn the lamp on? If it doesn't, the lift sensor is not working.