[Jamming] Pro907ex finisher issue SR5020

[bollard]

Remove paper from finisher shift tray .

Appears only on A4R when stapling to the shift tray ?

Replaced all exit sensors , drag roller assy sensors etc.

It appears as the paper enters the finisher I'm thinking size issue size guides all clean and sensors .

The machine does not return to ready screen until you open/close finisher door.

[slimslob]

Re: Pro907ex finisher issue SR5020

Machine thinks that the shift tray stack is full. Check that the arm that sets on the top of the stack moves freely.

[bollard]

Re: Pro907ex finisher issue SR5020

Machine thinks that the shift tray stack is full. Check that the arm that sets on the top of the stack moves freely.

Yes the arm has also being changed including all sensors !