AFICIO 1075 (Fusing unit is installed incorrectly, or B2)

[omorales]

Hello friends wanted to know if someone had this problem. The team suggests that this misplaced fusion unit was verified and is well ok, ok sensors lamps, lights thermistor ok.
Section B2 also indicates sensor registration was verified ok,.


Any help will be appreciated.

[Counsel]

Re: AFICIO 1075 (Fusing unit is installed incorrectly, or B2)

I am not quite sure I understand which is wrong, the gate is closed but showing its not or a fusing unit error. If the gate is closed but saying its open check the sensor at the rear and make sure its not covered in dust or toner. As for the fusing unit if its saying its not installed correctly check or replace the harness make sure there is not paper stuck in the machine side and fusing unit connector, if thats clear make sure the connector tabs are not damaged, I also remember putting some thin washers on the fusing unit connector behind the plastic to bump it out a bit so it would make better contact with the machine.

The harness is B1404162 NA version. B1404164 EU version.