[Misc] MPC2011 printing slow

[wouterp]

Have an issue with MPC2011 printing slow out of Dicom Application (X-Ray program at Hospital). Prints fine from MPC2051 but when I switch to MPC2011 the printer spools for about 5 minutes per file. Used PCL5c, PCL6 and Universal drivers - no change. All firmware up to date. Please if anyone had a similar problem, please advise.

[bjakobs]

Re: MPC2011 printing slow

Is printing in general slow, or is it just from Dicom? Are there differences between the pcl5,pcl6 and UPD in speed and size of spool file? Is gigabit enabled on the NIC?

[wouterp]

Re: MPC2011 printing slow

Is printing in general slow, or is it just from Dicom? Are there differences between the pcl5,pcl6 and UPD in speed and size of spool file? Is gigabit enabled on the NIC?

Printing in general is not slow, just Dicom. No difference in PCL5C, PCL6 or UPD in speed or spool file. Copier only works on 100mb full duplex, no other setting.

[rsyarcia]

Re: MPC2011 printing slow

Printing in general is not slow, just Dicom. No difference in PCL5C, PCL6 or UPD in speed or spool file. Copier only works on 100mb full duplex, no other setting.

You should set the ethernet speed to Auto Select: Enable 1Gbps.

[wouterp]

Re: MPC2011 printing slow

You should set the ethernet speed to Auto Select: Enable 1Gbps.

Tried that, but only works on 100mb/full duplex.

[wouterp]

Re: MPC2011 printing slow

Disconnect MP C2051, give the MP C2011 the IP of the MP C2051 and try to print with this driver. Is this successful or still the same problem?

Did that, still the same problem

[rsyarcia]

Re: MPC2011 printing slow

we have one customer, when they set the ethernet speed to 100mb/full duplex the machine starts to crawl.

[wouterp]

Re: MPC2011 printing slow

we have one customer, when they set the ethernet speed to 100mb/full duplex the machine starts to crawl.

Will try to get the other speeds to work. Thanks for the tip.