I have a problem with this m/c throwing these codes at very short terms
after a catastrophic SC-982 when it lost everything about settings.
I did a firmware upgrade to all modules (fax included)and it seemed everything
was normal, but few days later it started coding, standby mode, scanning, printing mode.
M/c has only 90,000 prints and no service has been performed yet.
So far, i have replaced HV board,Transfer roller, Printer Controller and Fax board....
BICU board also...
Maybe the trigger is the SC-402...well, any help is much appreciated,
Thanks in advance.
after a catastrophic SC-982 when it lost everything about settings.
I did a firmware upgrade to all modules (fax included)and it seemed everything
was normal, but few days later it started coding, standby mode, scanning, printing mode.
M/c has only 90,000 prints and no service has been performed yet.
So far, i have replaced HV board,Transfer roller, Printer Controller and Fax board....
BICU board also...
Maybe the trigger is the SC-402...well, any help is much appreciated,
Thanks in advance.
Comment