MP C3003 806182 sp mode not working

[richard_hosea25]

I have a mp c3003 machine after performing clear all memory
I couldnt enter the sp mode by 806182, can somebody help me how to
retrieve it. Thanks.

[TonerMunkeh]

Re: MP C3003 806182 sp mode not working

Why did you memory clear it? Did you not have a backup of it's NVram?

[richard_hosea25]

Re: MP C3003 806182 sp mode not working

Yes I have, but using
The 143 sp mode does not show the nvram download.

[Nikolay]

Re: MP C3003 806182 sp mode not working

In the Administrator menu, it is necessary to ensure that access is not prohibited. The access code can be changed earlier.

[slimslob]

Re: MP C3003 806182 sp mode not working

Why did you memory clear it? Did you not have a backup of it's NVram?

Yes I have, but using
The 143 sp mode does not show the nvram download.

You still have not said why you did the memory clear. Normally that should only be done at the direction of tech support and when you are currently talking to them. That way if you have a problem afterwards, they can help you.

[richard_hosea25]

Re: MP C3003 806182 sp mode not working

I found a forum in copytech by clearing the memory it will clear the data of nvram
previously it was showing sc 995-02. Does it change the settings if I change new nvram with
old data, or changing the eeprom would change anything?

[Nikolay]

Re: MP C3003 806182 sp mode not working

That description of the error

SC995 D CPM setting error CTL
01
 Defective BCU
 NVRAM Replacement error
 Install the previous NVRAM.
 Input the serial number with SP5-811-004, and turn the
main power switch off and on.
02
 Defective NVRAM
 Defective controller
 Update the controller firmware.
 Install a new NVRAM, and turn off and on the main
power switch after SC995-002 has occurred.
03
 Incorrect type controller installed
 Defective controller
 Replace the controller with the correct type.
04  Incorrect model controller installed.
 Replace the controller with the correct model.

[imaginemoko]

Re: MP C3003 806182 sp mode not working

I found a forum in copytech by clearing the memory it will clear the data of nvram
previously it was showing sc 995-02. Does it change the settings if I change new nvram with
old data, or changing the eeprom would change anything?

changing the eeprom changes everything, serial number should be basically blank if its new so it will give you SC 995-** so you need to input serial numbers and should be identical with other serials, BICU, NOVITA, some stuff like that using clear 143 C+ C hold press. so if you have new nvram and download the old nvram data it should be fine if there are no sc error on that data otherwise if you had then your just transferring the corrupt data to your new nvram. anyhow good luck Sir.