Nashuatec D445 not printing

[rsyarcia]

I have problem in printing using the network(nib)I can't print but when I use parallel port it can print. Any idea on how to set up the NIB type 450E. tnx

[copytec]

Did you have NIB (IP adress) on config page from printer?

[iMind]

press: user tools, scroll to printer settings, ok\network setup, ok\IP address, ok input EX:192.168.100.1, ok\scroll to subnetmask, ok input EX:255.255.255.0 press ok. reboot the machine by turning off and back on.
hope this helps.

[rsyarcia]

hi

Mr. IMind,Copytec Tnx I already did what you told me and printed the config page now the machine has IP address, subnet mask and I can ping the machine but still it can't print.192.168.1.10, 255.255.255.0

[copytec]

Tray next:
when you configure TCP/IP port not use "Standard-Generic Network Card"
alredy RICOH Network Printer D model.

[cobiray]

Open the print properties window and click on the Ports tab. Select configure port for the IP port of the machine. Change the port type from RAW to LPR. Name the port lp (LP but lowercase) and enable byte counting. Try a test print then. If you still can't print, unplug the machine from the network and ping the IP again to verify another network device is not using that IP.

[rsyarcia]

Hi

Mr. cobiray your great!!! I did what you told me!! and it is working now.tnx. this website helps me a lot.