If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've not heard from him in a week now, so I'm going to say the "spool before printing" setting fixed the issue (now watch, since I said that I'll get a call from him within 24 hours for the same problem).
Haha....Yup. Murphy's Law! (Let's hope that's not the case).
Lots of helpful info in this thread. Thanks for the update Mika
Comment