LD 145 AF 2045

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • RicohTech
    Technician
    • Oct 2007
    • 30
    #1

    LD 145 AF 2045

    The copier goes dead, no power, dead intermittently. Lately when paper is put on the ADF, copier goes dead, no 5 volts, ie.... LED on op panel, intermittently, I couldn't duplicate.
    SC 670 was the only code it threw since this started happening again.
    This is the 2nd time I've come across this symptom in 6 months with this copier, 1st time, replaced the HDD and power supply and problem resolved.

    I've not been able to reproduce problem. I think it could be the controller/main board, which controls peripherals. Reseated board.

    Has anyone seen the problem?
    Tags: 145, 2045, cons, power supply, power supply board, symptom
    • rthonpm
      Field Supervisor

      2,500+ Posts
      • Aug 2007
      • 2847
      #2
      Sounds like your ADF is blowing a fuse on the board of the machine. I've seen finishers do this as well... Check fuse 101 on the power supply board.

        Comment

        • copyaction
          Senior Tech

          Site Contributor
          500+ Posts
          • Oct 2007
          • 985
          #3
          try running with finisher disconnected

            Comment

            • RicohTech
              Technician
              • Oct 2007
              • 30
              #4
              Power

              If it is a fuse, wouldn't the problem be constant instead of intermittent. I will be back sometime next week to check the fuse.
              And if it does lose power I will run it without the finisher, so far, I am unable to reproduce the problem.
              Thanks for the suggestions

                Comment

                Previous template Next
                Working...