mpc306 jamming

[slot]

we have an mpc306 that seems to be jamming at j03/j017/j057 but we can never get it to jam when we are there it also shows sc492 a lot in the smc
we have tried a new tray and replaced the transfer roller and transfer belt unit all to no avail has anyone got any better ideas apart from the feed and reg clutch thanks

[Polarbear]

Re: mpc306 jamming

Hi

The sc 492 relates to the high voltage power supply and it complains about the transfer bias being incorrect. Says to check contact between transfer and Hvpsu as well as seating of transfer roller. And blames bicu as last cause.

Where is the paper when the jam takes place? Is the paper creased and/or damaged?

Sent from my SM-G950F using Tapatalk

[FrohnB]

Re: mpc306 jamming

J003 = Paper did not make it out of tray one (usually green end fence too far back, or paper that has a folded corner holding up one side of the stack).
J017 and J057 = Paper making it to Reg sensor late, or paper not getting there at all.
SC492 "Usually" relates to 2nd Transfer Roller (not seated correctly, or completely worn out, or damaged). Check the Static teeth on the transfer roller and check the mylar on it too (That mylar gets cracked on front and rear sides and will cause jams).

What are the counters on this machine? If you don't see something completely obvious, then I would start leaning towards clutches, and in this machine, expect it to take like 4 hours to replace if it's your first time.

How often is it jamming? Customer loading paper badly?

[slot]

Re: mpc306 jamming

thanks for all your input we will give it a try.