If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Did everyone see there is a part number for just the mag roller now ? I wonder if just putting that in instead for the dev unit would be good enough ? I would think so there's not much else in the dev unit.
I would agree since the changes made were to the surface coating on the mag roller only.
Did everyone see there is a part number for just the mag roller now ? I wonder if just putting that in instead for the dev unit would be good enough ? I would think so there's not much else in the dev unit.
The only other difference in the unit is a much larger filter
Comment