Lanier LD127 (Aficio 2027) SC670

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • nb321
    Junior Member
    • Feb 2009
    • 8

    #1

    Lanier LD127 (Aficio 2027) SC670

    If machine goes to standby mode for few hours, on boot display SC670 code... (usually in the morning)... conections between board seems ok... any idea?
  • Jomama46
    Field Supervisor

    Site Contributor
    2,500+ Posts
    • Apr 2008
    • 2900

    #2
    Disconnect the HD temporarily to see if the problem goes away.
    sigpic
    You never realize how cheap a professional is until after you let an amateur do it.
    A+; Network +; PDI+

    Comment

    • Eric1968
      Service Manager

      1,000+ Posts
      • Jan 2009
      • 2458

      #3
      Could also be a defective network interface board.

      Comment

      • cobiray
        Passing Duplication Xpert

        1,000+ Posts
        • Mar 2008
        • 1199

        #4
        Ditto the HDD
        the savin2535 is displaying well bet the hiter lamp is not shining and the lamp had been tested o.k.please kindly help.
        Samir: No, not again. I... why does it say paper jam when there is no paper jam? I swear to God, one of these days, I just kick this piece of shit out the window.
        Michael Bolton: You and me both, man. That thing is lucky I'm not armed.

        Comment

        • TonerMunkeh
          Professional Moron

          2,500+ Posts
          • Apr 2008
          • 3865

          #5
          I think there's a firmware update for this, could be wrong like.
          It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.

          Hit it.

          Comment

          • Jimbo1
            Senior Tech

            500+ Posts
            • Mar 2008
            • 845

            #6


            It's a Ricoh. There's always a firmware update.

            "Some days you get the bear, some days the bear gets you."

            Cdr. William Riker

            Comment

            • nb321
              Junior Member
              • Feb 2009
              • 8

              #7
              thanks, guys... but this is only copier machine, doesn't have HDD and network interface. I never didn't firmware upgrade that type of machine, (it wasn't necessery on another hundred machines of that type that i service) can you help me with that? new models have sd card reader, and it's not a problem, but this one need some IC card?
              that machine had simular problem few months ago, and then problem is desapire after few days, but right now it's constantly here...

              Comment

              • Shadow1
                Service Manager

                Site Contributor
                1,000+ Posts
                • Sep 2008
                • 1642

                #8
                Bad connection to the op panel - resolder the connector for the interface cable - had several with cold solder joints that would give this sort of problem
                73 DE W5SSJ

                Comment

                • techspec
                  Trusted Tech

                  100+ Posts
                  • Dec 2008
                  • 128

                  #9
                  Remove the nvram and clean the legs with an emery cloth or scotchbrite, also a check of the SMC data might show up of few SC991 errors which go hand in hand with SC670

                  Comment

                  • tungnhung
                    Technician
                    • Dec 2008
                    • 26

                    #10
                    No response from BCU at power on

                    Comment

                    Working...