I have a customer who prints on 100gr paper only, with 60-70% coverage. Printer has 30K prints. Customer complains to me that sometimes printer throws unfused pages not all of the page, but a column top to bottom, right hand. I saw them and i checked hot/press roll but they look good. I would like to ask if someone have had the same experience and what is the cause... Fuser module lasts for 100K but is it true? Thanks in advance for any input!
-
-
Hallo The Maschine also the Driver must stand on thick Paper
I have no problems with the Fuserunits
Good Luck -
That is a high toner coverage for the fuser to cope with at full speed.
I agree with Meister77 sounds like it needs to go through on thick 1 (slower and slightly hotter).- Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
Fully qualified technician for Ricoh - Canon - Sharp - HP - BrotherComment
- Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
-
Thanks a lot for your response! I suggested to my customer a "coated paper" selection from printer driver, since than i didn't have any issue...
Comment
Comment