I have searched these forums for possible solutions and have it narrowed down to either the controller board or the HDD. Here is what is happening and what I have done. Everyhting is fine after power up initially, after several hours (during which device enters power save) device shows an SC672 error. I have entered service mode and re-formatted HDD (SP5832, followed by SP5853) and then re-booted does not clear error, and usually, but not every time get another error SC141-01. Power down device let it sit for several hours and everything is fine again, until several hours pass. I have not tried just disconnecting HDD and powering up nor have I done a loop back test on the controller. If someone has the pin out for the lop back device I can build one, but wnated to get more feed back here first.
The time factor leads me to believe heat may be a factor but not sure that enough heat is building up to be a factor, as eerything seems to be at worst just warm to the touch. Anyone have any ideas?
The time factor leads me to believe heat may be a factor but not sure that enough heat is building up to be a factor, as eerything seems to be at worst just warm to the touch. Anyone have any ideas?
Comment