ricoh 1045

[hodgiepodgie]

ok need to add stamp option.one copier has stamp feature so i want to copy it to flash card then load it onto another 1045.how is this done?

[schooltech]

I know that it is one of the firmware update options, but I don't think you will be able to just load the stamp firmware, I think you'll have to back up other firmware packages from the machine to the card, but that shouldn't be a big deal. There is a service mode to dump the firmware to a card in the 5-xxx I believe.

I am also pretty sure that this is one of the few things actually stored on the HDD, so if the HDD goes out, so does the stamp data.

This is definitely something I have not done on a regular basis.

[Eric1968]

RTB1 says the following :

This software installs the stamp data to be used for the copier function into the Adonis-C2
hard drive. Since this software is installed at the factory, this procedure is normally not
necessary. However, it must be done whenever the hard drive has been reformatted or
replaced since being released from the factory.

Installing the Stamp Software
1. Upload the Stamp software to an IC card, then insert the card into the controller IC
card slot.
2. Turn the main power on. (It is not necessary to change any Dip SW settings).
3. When .Download Watermark. is displayed on the operation panel, press .Ok..

4. After the installation has been completed, turn off the main power.

Attached file is the .bin-file for the stamp firmware

[aabarnes1]

I've just spent the las t 20 mins searching around on this and I have to agree with Eric 1690