Mpc 3500 (b222) fuser

[mikadonovan]

What is the part number for the printer fuser assy. I dont see it listed in the parts cat?

It's probably listed as a supply item.

[Jomama46]

It's probably listed as a supply item.

You're right, thanks

[E Winter]

we dont rebuild them, we take the fusing unit of the spc811 printer, you only have to change one pin on the connector with the red wires. just put both units side by side and compare the wires and you see what i mean.saves lot of money and time.

Works on mpc 3500 and 4500 and btw. you can interchange the transfer belt unit also, just change the upper plates

Yeah we do it the same way - afaik the complete fuser unit for the SPC series is cheaper than a fuser kit for the copier (and you'll get a transfer roller 4 free)

[Noj7373]

I tried on of the printer version fuser's, It through up SC549, and seems to have an added wire harness with a resistor. Anyone run into this?

[Froota]

we dont rebuild them, we take the fusing unit of the spc811 printer, you only have to change one pin on the connector with the red wires. just put both units side by side and compare the wires and you see what i mean.saves lot of money and time.

Works on mpc 3500 and 4500 and btw. you can interchange the transfer belt unit also, just change the upper plates

Hello,

Is there a picture or manual sheet available for this change?
We want to use the fusing from the printer version into the copier, but if you have a bit experience with the swap, maybe a close-up of the connector or handeling could be usefull.

thx anyway,

Froota

[trebor]

mpc4500 fuser replacement with 402719

You can order the replacement fuser and it comes with a transfer roller you have to swop harnesses because there is a shorting link (The bottom two pins on the printer and the third and second from bottom on the copier) moving the bottom pin up to the third from bottom has the same effect. also this will allow you to stock pile fusers and not have to make the mod at the customers ( unless of course the on T&M.