If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I need an advice from experienced techs about parts replacment (drums,developers,Blades,Brushes) on A3260c. What is an exact procedure that U use for replacment and combination of SPs? Service Manual is a bit fuzzy obout this mater. Thanks
after you replace the pm parts either 150k and/or 300k pm in service mode select the pm parts list and clear each of the parts that you replaced. simple.
Get your facts first, and then you can distort them as much as you please.
Comment