If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had many problems with these machines more unit.laser learned to disassemble and clean the laser diode is inside the glass that the laser diode and thus solves the problem without having to replace the LD
1 drawing of the LD unit 03 screws
2 remove the soldering of diodes six (06) solders and two screws, remove the card from the LD.
3 get four (4) screws from a plate of iron.
4 remove the seal top and bottom of paper and take the lock.
5 clear the mirror that is within the laser gun and then put everything in place novamente.limpe all internal parts as the eyes of the diode.
I hope that you understand the steps as they do straight vai dar certo
Comment