CL 7000 with code 741

[firmwareislost]

Hi there,

Since a couple of weeks a cl 7000 is playing games.

First time sc 741 I pulled out the transfert belt unit, replaced it and the

code was gone for a couple of weeks.

Last time i cleaned the HP sensor and checked the lift system of the transfert belt unit, it was all ok.

Now I ve got the same machine with the same code AGAIN !! GRRR..!!

Any ideas where to look, or to check ??,

what to replace (sensor ?) little motor that lifts the

transfert belt...?

Thanks !

Marc

[Jomama46]

Move to the left. SC741 is a finisher code. Specifically, the paddle motor.

SC741: Booklet finisher paddle motor error.
The paddle HP sensor does not turn off within 2 seconds after the paddles start to move. The paddle HP sensor does not turn on within 2 seconds after the paddles start to operate. The stack tray upper roller HP sensor does not turn off within 2 seconds after the paddle motor starts to lower the roller. The stack tray upper roller HP sensor does not turn on within 2 seconds after the paddle motor starts to lower the roller.
Defective paddle motor; Defective paddle HP sensor; Defective stacl tray upper roller HP sensor.

[firmwareislost]

Sorry was confiused..

The code was 471...

I mixed up the numbers in my thread...

sorry again !!

Marc

[Jomama46]

lube the camshaft; replace the sensor.
If it comes back, replace the motor.