Ricoh 3260c (Color) USA SC412 error

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • rapidcopierserviceco
    Rapid Copier Service Co
    • Apr 2008
    • 10
    #1

    Ricoh 3260c (Color) USA SC412 error

    i have a ricoh 3260c (color) USA version with a error sc 412. I need to identify the problem and whats the solution(s). any help out there?

    Happy Thanksgiving all.....

    email to rapidcopier@aol.com
    We provide other dealers with great service on products they don't normally carry. Don't turn away that service call. We can service just about all make and models from most manufacturers. We have factory trained technicians, parts, maintenance kits etc.
    We will do the service under your company while YOU work on upgrading the customer to the products that YOU carry.
    Rapid Copier Service Co
    www.rapidcopier.com
    215-942-9766
    866-891-1620
    Fax 215-942-9768
    Tags: 3260c, color, error, gamma, id sensor, lef, release, ricoh, sc412, sensor error, symptom
    • totoro
      Senior Tech

      Site Contributor
      500+ Posts
      • Apr 2008
      • 568
      #2
      From the service manual:

      SC410 D
      ID sensor error 2: Development γ K

      SC411 D
      ID sensor error 3: Development γ M

      SC412 D
      ID sensor error 4: Development γ C

      SC413 D
      ID sensor error 5: Development γ Y
      Development gamma for black,
      magenta, cyan, or yellow is not
      within range (0.3 to 6.0).
      Process control halts when this
      SC is issued.

      Toner density not normal: Refer to the
      procedure for process control self-check
      error codes 55 to 59 to 59, and 61
      (section 4.2.4)

      Potential sensor defective

      Laser diode not firing

      ITB separation for CMY abnormal

      Transfer power pack defective

      ID sensor defective

      If after service or installation, check ITB

      release lever.


      I would clean all the ID sensors first and see what happens.
      Totoro

        Comment

        • sakura
          Trusted Tech
          • Dec 2009
          • 132
          #3
          [Symptom]
          When the PCU units were initialized after delivery, SC412 (ID Sensor Error 2: Development Gamma CYAN) appeared.
          Copies showed almost no Cyan.

          [Cause]
          The transfer belt release lever was not set properly, so the correct pressure was not applied to the belt.

          [What to do]
          The transfer belt release lever was set properly.
          Slack in the ITB can foul the ID sensors with toner, so check and clean them.

          Be very careful when you install and initialize new PCUs/developers. You have to follow procedures exactly as mentioned in Ricoh manuals.

          Hope it helps.

            Comment

            • sakura
              Trusted Tech
              • Dec 2009
              • 132
              #4
              [Symptom]
              When the PCU units were initialized after delivery, SC412 (ID Sensor Error 2: Development Gamma CYAN) appeared.
              Copies showed almost no Cyan.

              [Cause]
              The transfer belt release lever was not set properly, so the correct pressure was not applied to the belt.

              [What to do]
              The transfer belt release lever wasn't set properly.
              Slack in the ITB can foul the ID sensors with toner, so check and clean them.

              Be very careful when you install and initialize new PCUs/developers. You have to follow procedures exactly as mentioned in Ricoh manuals.

              Hope it helps.

                Comment

                Previous template Next
                Working...