Have 4 of these machines on a site 3 of them have a java platform (via GM SD card) they all accepted a P counter software programme the fourth would not (machines have consecutive serial numbers).
I tried replacing the controller but machine would not accept new board even with old Nov ram board fitted.
Came up wrong type of controller, so investigated TB's and found new part number for controller, ordered and fitted that still same fault if I replace with original board by the way the machine copies and prints, just will not accept P counter system.
Any ideas anyone?
I tried replacing the controller but machine would not accept new board even with old Nov ram board fitted.
Came up wrong type of controller, so investigated TB's and found new part number for controller, ordered and fitted that still same fault if I replace with original board by the way the machine copies and prints, just will not accept P counter system.
Any ideas anyone?