tis problem has been going on for months now and i just cant get to the bottom of this. machine throws up an sc 388 nearly everyday in the morning hen switching machine on. when i did a test colour in service i found that the cyan was not as strong as it should be. its faint. the other colours are perfect.
ive replaced all drums and narly all dev units especially the cyan dev unit. the dev is turning freely. the inside of the machine is very clean and vacd out. the springs that come in to contact of the end of the pcu are in place.
id sensors are clean
is there anyway i can disable the colour? becuse the customer only uses b+w. how can i fix this problem
ive replaced all drums and narly all dev units especially the cyan dev unit. the dev is turning freely. the inside of the machine is very clean and vacd out. the springs that come in to contact of the end of the pcu are in place.
id sensors are clean
is there anyway i can disable the colour? becuse the customer only uses b+w. how can i fix this problem
Comment