If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
i have a ricoh 1027 thats not letting me into the system settings and everytime i do it comess up wit a key operator code message. i cant type any letters or supervisor or admin. just numbers. how do i turn it off apart from replacing the nvram?
810 Key Operator Code Reset
Use to clear the key operator code if the key operator
forgets the code. After clearing the code is reset for
Null and the password entry display does not open. To
clear, press Execute on the touch panel.
Comment