If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When using the cover interposer after approx 30 sets funtional error shows on display. SC990 is logged in smc data. This is a recurring issue and only happens when doing cover insertion. Have reflashed with latest firmware. Any other ideas?
Can you tell a bit more about the configuration. What finisher do you use? Try to update the finisher firmware. For MP6000 is also available some custom firmware that suppose to fix the problems with accessories like GBC Streampunch. You can try that firmware
Comment